Workshop

FORD 5R55S/5R55W

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
47
Figure 73
Copyright © 2004 ATSG
OVERDRIVE PLANETARY
CARRIER ASSEMBLY
OVERDRIVE PLANETARY
CARRIER TO CENTER SHAFT
THRUST BEARING
OVERDRIVE
RING GEAR
OVERDRIVE
SPRAG ASSEMBLY
OVERDRIVE
CENTER SHAFT
CENTER SHAFT TO
RING GEAR SNAP RING
OVERDRIVE CARRIER AND SPRAG ASSEMBLY
1. Disassemble the overdrive carrier from center
shaft using Figure 73 as a guide.
2. Inspect all of the overdrive carrier parts shown
in Figure 73 for any wear and/or damage.
3. Clean all overdrive carrier parts thoroughly and
dry with compressed air.
4. Install the overdrive sprag assembly into the
overdrive center shaft, in the direction shown
in Figure 74, until fully seated.
5. Install thrust bearing onto overdrive carrier, as
shown in Figure 75, and retain with a small
amount of Trans-Jel®.
6. Install completed overdrive center shaft onto
the overdrive carrier by rotating shaft counter
clockwise as you install (See Figure 76).
7. Verify proper overdrive sprag rotation, using
Figure 76, and then set the overdrive planetary
carrier assembly aside for final assembly.
OVERDRIVE CARRIER/SPRAG EXPLODED VIEW
Continued on Page 48

Leave a Reply

Your email address will not be published. Required fields are marked *