Workshop

FORD 5R55S/5R55W

REAR LUBE DAM
OUTPUT SHAFT
SNAP RING
P1L 7A039 BA2 - -
rdFo
Copyright © 2004 ATSG
Copyright © 2004 ATSG
Copyright © 2004 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
35
Figure 49
Figure 48
Figure 47
Continued on Page 36
INTERNAL COMPONENTS (Cont'd)
REAR PLANETARY
THRUST BEARING
(NO. 8)
REAR PLANETARY
SNAP RING
REAR PLANETARY
ASSEMBLY
52. Remove the rear planetary carrier from the
reverse drum, as shown in Figure 47.
53. Remove the plastic lube dam from the rear
planetary ring gear, as shown in Figure 48.
54. Remove the output shaft retaining snap ring
from the output shaft, as shown in Figure 48.
Caution: Install temporary strap on back of
case, as shown in Figure 49, to retain the
output shaft from falling out, "before" you
remove the snap ring.
CAUTION: INSTALL TEMPORARY
HOLDING STRAP AS SHOWN TO
RETAIN OUTPUT SHAFT.

Leave a Reply

Your email address will not be published. Required fields are marked *