Workshop

FORD 5R55S/5R55W

Copyright © 2004 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
33
DIRECT CLUTCH
DRUM ASSEMBLY
DIRECT CLUTCH
"SELECTIVE"
THRUST BEARING
(NO. 4)
FORWARD CLUTCH
THRUST BEARING
(NO. 5)
FORWARD CLUTCH
THRUST BEARING
(NO. 6A)
Continued on Page 34
INTERNAL COMPONENTS (Cont'd)
38. Remove the center support and set aside for
component rebuild, as shown in Figure 43.
39. Remove the intermediate band assembly and
both band struts, as shown in Figure 43.
Note: Notice the difference in the band struts
and which side they are located, as shown in
Figure 43.
40. Remove and tag for I.D. direct clutch (No. 4)
selective thrust bearing, as shown in Figure 44.
41. Remove the direct clutch housing assembly and
set aside for component rebuild, as shown in
Figure 44.
42. Remove and tag for I.D. forward clutch (No. 5)
thrust bearing, as shown in Figure 44.
43. Remove the forward clutch housing assembly
and set aside for component rebuild, as shown
Figure 44.
44. Remove and tag for I.D. the forward clutch
(No. 6A) thrust bearing (See Figure 44).
Note: This bearing may stick to the forward
clutch housing during removal.
Figure 43 Figure 44
INTERMEDIATE
BAND
BAND STRUT
ADJUST SIDE
BAND STRUT
SERVO SIDE
FORWARD CLUTCH
DRUM ASSEMBLY
Copyright © 2004 ATSG

Leave a Reply

Your email address will not be published. Required fields are marked *