Workshop

FORD 5R55S/5R55W

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
32
INTERNAL COMPONENTS (Cont'd)
Figure 40
Figure 42
Continued on Page 33
OVERDRIVE CARRIER
AND CENTER SHAFT
ASSEMBLY
CENTER SUPPORT
"TAPERED"
SNAP RING
CENTER SHAFT
THRUST BEARING
(NO. 3)
CENTER SUPPORT
ASSEMBLY
Figure 41
Copyright © 2004 ATSG
Copyright © 2004 ATSG
34. Remove the overdrive carrier and center shaft
assembly, as shown in Figure 40.
35. Now, remove the center support retaining bolt
from the case, as shown in Figure 41, and also
remove the locknut, as shown in Figure 42, to
prevent it from falling into the assembly.
36. Remove the center support retaining snap ring
from the case, as shown in Figure 42.
37. Remove center shaft thrust bearing (No. 3)
from the center support, as shown in Figure 42
and tag it for I.D. and location.
Fo d
r
SG A
6540
3
R 19 A
6538
R3 T9 A
DA 8
Ford
CENTER SUPPORT
RETAINING BOLT
(20mm LENGTH)
Copyright © 2004 ATSG
96
M 07
1624

Leave a Reply

Your email address will not be published. Required fields are marked *