Workshop

FORD 5R55S/5R55W

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
26
Copyright © 2004 ATSG
Copyright © 2004 ATSG
EXTERNAL COMPONENTS (Cont'd)
9. Rotate the transmission so that the bottom pan
is facing up, as shown in Figure 27.
10. Remove the sixteen bottom pan bolts using an
8mm socket and remove oil pan, as shown in
Figure 28.
11. Remove the bottom pan gasket from the case,
as shown in Figure 28.
Note: The bottom pan gasket is reuseable.
Clean and inspect the gasket for damage, and
if it is not damaged, it may be re-used.
12. Remove the two filter retaining bolts, as shown
in Figure 29, and remove and discard the oil
filter and seals.
13. Remove the four rear servo retaining bolts and
remove the Low/Reverse Servo assembly, as
shown in Figure 30.
14. Set the Low/Reverse Servo assembly aside for
the component rebuild process.
Continued on Page 28
Figure 28 Figure 29
Ford
GA8
605
4
319AR
6538
R T9 3 A
CA 0
Ford
21
6 -21
6 -
PAN GASKET
PAN BOLTS
(16 REQUIRED)
Frdo
GA8
6540
R3 19 A
5
6 3 8
R3 T9 A
CA 0
Fo
rd
-6 2 1
-6 2 1
OIL FILTER
RETAINING BOLTS
(82mm LENGTH)
15. Remove the eight solenoid body retaining bolts
using a 30 Torx bit, as shown in Figure 30.
16. Remove the solenoid body assembly from the
transmission, as shown in Figure 30, and set
aside for testing in component rebuild.

Leave a Reply

Your email address will not be published. Required fields are marked *