Workshop

FORD 5R55S/5R55W

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
103
Continued on Page 104
Figure 184
Ford
XW4P-7H
103 AA
XW4P-7M
103 AA
Turbine And Output
Shaft Speed Sensor
Intermediate Shaft
Speed Sensor
Fdor
Line Pressure Tap
(Pressure Control Solenoids "A" And "B")
Copyright © 2004 ATSG
4CXP-
A
W
-RJL
B
-J
R
L
B
0 3
1
046
43
0
0 6
1
C
1
7B
D
-9
Pressure Control Solenoid "C"
Pressure Tap
Figure 185
EXTERNAL COMPONENTS (Cont'd)
4. Install the outer manual control lever and nut,
torque nut to 48 N•m ( 35 ft.lb.).
5. Install a new "O" ring on turbine speed sensor
and install into case in the location, as shown in
Figure 183.
Note: Use Figure 184 to identify the three
speed sensor assemblies, and use the chart
on Page 17 for proper Ohms readings.
6. Install a new "O" ring on the intermediate shaft
speed sensor and install into case in the location
shown in Figure 183.
Note: Use Figure 184 to identify the three
speed sensor assemblies, and use the chart
on Page 17 for proper Ohms readings.
7. Install a new "O" ring on output shaft speed
sensor and install in case in the location shown
in Figure 183.
Note: Use Figure 184 to identify the three
speed sensor assemblies, and use the chart
on Page 17 for proper Ohms readings.
8. Torque all three speed sensor retaining bolts
to 10 Nm (89 in.lb.).
9. Check and ensure that both oil pressure plugs
are tight, as shown in Figure 185.

Leave a Reply

Your email address will not be published. Required fields are marked *