Workshop

FORD 5R55N

TORQUE CENTER SUPPORT BOLT
TO 11 Nm (100 in.lb.)
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
99
Copyright © 2001 ATSG
Figure 172
DA 8
Ford
INTERMEDIATE CLUTCH
SEAL RETAINING SPRING
INTERMEDIATE BAND
ADJUSTING SCREW
OVERDRIVE BAND
ADJUSTING SCREW
INTERMEDIATE
CLUTCH SEAL
Figure 171
Ford
Copyright © 2001 ATSG
Figure 170
FordFord
GA
S
GA
S
65406540
R3 19 AR3 19 A
653
8653
8
R3 T9 AR3 T9 A
DA 8DA 8
FordFord
Copyright © 2001 ATSG
INTERNAL COMPONENTS (Cont'd)
63. Install new locking nuts on both band adjusting
screws, using care not to let the adjusting screw
come out, so that the band anchors will not fall
out and into transmission (See Figure 171).
64. Adjust the overdrive band by turning adjusting
screw in while holding the lock nut. Torque
the adjusting screw to 14 Nm (10 ft.lb.) and
then back out exactly two (2) full turns. Refer
to Figure 171.
65. Adjust intermediate band by turning adjusting
screw in while holding the lock nut. Torque
the adjusting screw to 14 Nm (10 ft.lb.) and
then back out exactly two (2) full turns. Refer
to Figure 171.
66. Install intermediate clutch seal and retaining
spring into the transmission case cavity, shown
in Figure 172.
Caution: This seal should be installed using a
drift punch and installed by hand to ensure it
is fully seated against housing.
Continued on Page 100

Leave a Reply

Your email address will not be published. Required fields are marked *