Workshop

FORD 5R55N

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
98
Figure 168
OIL PUMP ASSEMBLY
RETAINING BOLTS
(8 REQUIRED)
OIL PUMP
ASSEMBLY
OIL PUMP
TO CASE
GASKET
Copyright © 2001 ATSG
98
X
W
9
9
4
/
P
1
-
0
7
/
L
9
6
0
6
9
-
A
B
Figure 169
Copyright © 2001 ATSG
INTERNAL COMPONENTS (Cont'd)
57. Install the oil pump to case gasket into case, as
shown in Figure 168, and align holes.
58. Lubricate the case bore where the "O" ring
rides with a small amount of Trans-Jel®.
59. Install the pre-assembled oil pump assembly
into the case, as shown in Figure 168, using
care not to damage the pump "O" ring.
60. Install the eight oil pump assembly retaining
bolts, and torque to 25Nm (18 ft.lb.), as shown
in Figure 169.
61. Rotate the transmission so that the valve body
surface is facing up, as shown in Figure 170.
62. Torque the center support retaining bolt down
to 11 Nm (100 in.lb.), (See Figure 170).
TORQUE PUMP BOLTS
TO 25 Nm (18 ft.lb.)

Leave a Reply

Your email address will not be published. Required fields are marked *