Workshop

FORD 5R55N

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
93
Figure 157
Ford
GAS
6540
R3 19 A
653
8
R3
T9 A
DA 8
Ford
CENTER SUPPORT
RETAINING BOLT
(20mm LENGTH)
Copyright © 2001 ATSG
Figure 156
CENTER SUPPORT
"TAPERED"
SNAP RING
CENTER SHAFT
THRUST BEARING
(NO. 3)
CENTER SUPPORT
ASSEMBLY
Copyright © 2001 ATSG
96
M 07
1624
Continued on Page 94
INTERNAL COMPONENTS (Cont'd) INTERNAL COMPONENTS (Cont'd)
35. After you have recorded the first measurment,
install the pre-assembled direct clutch housing,
as shown in Figure 153, by rotating back and
forth until fully seated.
36. Install the number 4 thrust bearing in position
on the direct clutch drum, in the direction that
is shown in Figure 153.
37. Install the intermediate band into transmission
and around the direct clutch housing, as shown
in Figure 154.
38. Install the intermediate band struts on each side
of the band, exactly as shown in Figure 155.
Caution: The anchor or adjustment side must
have strut installed that is illustrated in Figure
155 and must be installed with the small notch
facing the top of transmission.
The apply or servo side must also be installed,
as shown in Figure 155.
39. Install the center support assembly, ensuring
that you align the hole for the center support
with the proper passage (See Figure 156).
40. Loosely install the center support retaining bolt
as shown in Figure 157.

Leave a Reply

Your email address will not be published. Required fields are marked *