Workshop

FORD 5R55N

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
91
DIRECT CLUTCH
DRUM ASSEMBLY
DIRECT CLUTCH
"SELECTIVE"
THRUST BEARING
(NO. 4)
FORWARD CLUTCH
THRUST BEARING
(NO. 5)
FORWARD CLUTCH
THRUST BEARING
(NO. 6A)
CENTER
SUPPORT
DIAL
CALIPER
DIRECT
CLUTCH
HOUSING
NO. 4
SELECTIVE
THRUST
BEARING
Copyright © 2001 ATSG
Figure 151 Figure 152
FORWARD CLUTCH
DRUM ASSEMBLY
96
M 07
1624
4321
1 2 3 4 5 6 7 8 9 1 2 3 4 5 6 7 8 9 1 2 3 4 5 6 7 8 9 1 2 3 4 5 6 7 8 9 1 2 3 4 5 6 7 8 9 1 2 3 4 5 6 7 8 9
5 6
10 20 30 40 50 60 70 80 90 150140130120110100
0
in
mm
ELECTRONIC
DIGITAL CALIPER
AUTO POWER-OFFAUTO POWER-OFF
mm/inmm/in 00
00.725
IN
Copyright © 2001 ATSG
"Selective"
Continued on Page 93
INTERNAL COMPONENTS (Cont'd)
29. Install forward clutch thrust bearing (No 6A)
onto the back side of pre-assembled forward
clutch drum, in direction shown in Figure 151,
and retain with a small amount of Trans-Jel®.
30. Install forward clutch thrust bearing (No 5) on
front side of forward clutch drum, in direction
shown in Figure 151, and retain with a small
amount of Trans-Jel®.
31. Install forward clutch housing, with bearings,
as an assembly, as shown in Figure 151.
32. Caution: The thrust bearing (No 4) that goes
between direct clutch drum and center support
is "Selective" and a measurement must be
made before installation.
33. Assemble the selective bearing, direct clutch
housing and center support, on the bench, as
shown in Figure 152.
34. Measure with a dial caliper through the speed
sensor hole down to the surface of the direct
clutch housing, as shown in Figure 152, and
record this as dimension "A".

Leave a Reply

Your email address will not be published. Required fields are marked *