Workshop

FORD 5R55N

F
o
r
d
X
W
4
F
P
R
E
4
1
A
D
D
0
5
5
-
C
A
FORWARD CLUTCH
THRUST WASHER
(NO. 6B)
FORWARD PLANET
THRUST BEARING
(NO. 7)
FORWARD PLANET
ASSEMBLY
FORWARD RING
GEAR AND HUB
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
90
Figure 149
SPECIAL TOOL
NUMBER 307-401
Copyright © 2001 ATSG
Figure 150
INPUT SUN SHELL
INTERMEDIATE SPRAG
ASSEMBLY
Copyright © 2001 ATSG
Continued on Page 91
INTERNAL COMPONENTS (Cont'd)
21. Install the special tool, as shown in Figure 149,
to compress the intermediate clutch bellville
spring.
22. Compress the bellville return spring and install
retaining snap ring for the intermediate clutch
piston retainer (See Figure 148).
Caution: Ford recommends replacing this
snap ring on all rebuilds.
23. Remove the compression tool.
24. Install the pre-assembled input shell and sprag
assembly, as shown in Figure 150, by rotating
into position.
25. Install the pre-assembled forward planetary
assembly, as shown in Figure 150, by rotating
into position.
Caution: Ensure that snapped in thrust
washer is still in position.
26. Install forward planetary thrust bearing (No 7),
in the direction shown in Figure 150, and retain
with a small amount of Trans-Jel®.
27. Install the forward ring gear and hub, as shown
in Figure 150, by rotating into position.
28. Install forward clutch thrust washer (No. 6B),
as shown in Figure 150.

Leave a Reply

Your email address will not be published. Required fields are marked *