Workshop

FORD 5R55N

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
89
Continued on Page 90
INTERNAL COMPONENTS (Cont'd)
17. Install the rear planetary thrust bearing (No 8)
onto rear planetary in the direction shown in
Figure 146, and retain with a small amount of
Trans-Jel®.
18. Install the low/reverse spacer on top of the rear
planetary thrust bearing (No 8), in the direction
shown in Figure 147, and retain with a small
amount of Trans-Jel®.
19. Install the pre-assembled intermediate clutch
housing assembly into the transmission case,
as shown in Figure 148, and ensure it is fully
seated.
20. Install the pre-assembled intermediate piston
retainer assembly into the transmission case,
as shown in Figure 148.
Figure 147
LOW/REVERSE
SPACER
Copyright © 2001 ATSG
Figure 148
INTERMEDIATE PISTON
RETAINER SNAP RING
INTERMEDIATE PISTON
RETAINER AND PISTON
ASSEMBLY
INTERMEDIATE CLUTCH
HOUSING ASSEMBLY
Copyright © 2001 ATSG
7
N
0
6
P
-
1
4
-
D
W
A
X

Leave a Reply

Your email address will not be published. Required fields are marked *