Workshop

FORD 5R55N

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
88
Figure 145
REAR LUBE DAM
OUTPUT SHAFT
SNAP RING
Copyright © 2001 ATSG
REAR PLANETARY
SNAP RING
REAR PLANETARY
ASSEMBLY
Figure 146
Copyright © 2001 ATSG
REAR PLANETARY
THRUST BEARING
(NO. 8)
REAR PLANETARY
THRUST BEARING
(NO. 9)
Continued on Page 89
INTERNAL COMPONENTS (Cont'd)
11. With the pan rail still facing up, install output
shaft snap ring into the groove in the output
shaft and ensure that it is fully seated. Refer to
Figure 145.
Caution: This must be done with pan rail
facing up, so that output shaft does not fall
out and possibly create injury.
12. Now the transmission can be rotated so that
bell is facing up, as shown in Figure 145.
13. Install the plastic rear lube dam into rear ring
gear in the direction shown in Figure 145.
14. Install the rear planetary thrust bearing (No 9)
into rear ring gear in the direction shown in
Figure 146, and retain with a small amount of
Trans-Jel®.
15. Install the rear planetary carrier assembly, as
shown in Figure 146, by rotating into position.
16. Install the rear planetary snap ring into groove
in reverse drum and ensure it is fully seated.
(See Figure 146). Note: Reverse drum will
must be lifted up to install snap ring.

Leave a Reply

Your email address will not be published. Required fields are marked *