Workshop

FORD 5R55N

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
86
Figure 141
REVERSE DRUM
AND LOW SPRAG
ASSEMBLY
LOW/REVERSE
BAND ASSEMBLY
Copyright © 2001 ATSG
REAR PLANETARY
RING GEAR THRUST
BEARING (NO. 10)
Continued on Page 87
FINAL TRANSMISSION ASSEMBLY
INTERNAL COMPONENTS
1. Rotate transmission in fixture so that front of
case is facing up, as shown in Figure 141.
2. Install the reverse band into transmission, as
shown in Figure 141, ensuring that it engages
on the band anchor lugs in the case.
3. Compress the reverse band enough to engage
the reverse band lever into the notches in the
reverse band.
4. Install reverse drum and low sprag assembly
into the reverse band, as shown in Figure 141,
by rotating in a clock-wise direction.
5. Install rear planetary ring gear thrust bearing
(Number 10) into the case in direction shown
in Figure 141.
6. Install the pre-assembled rear planetary ring
gear that has the seal ring with the notches in
it, as shown in Figure 142.
Figure 142
REAR PLANETARY
RING GEAR
Copyright © 2001 ATSG

Leave a Reply

Your email address will not be published. Required fields are marked *