Workshop

FORD 5R55N

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
79
Figure 128 Figure 130
Figure 129
Copyright © 2001 ATSG
Copyright © 2001 ATSG
NUMBER ELEVEN
THRUST WASHER
Continued on Page 81
TRANSMISSION CASE ASSEMBLY
1. Inspect the transmission case thoroughly for
wear, damaged surfaces, or stripped threads.
2. Inspect the rear case caged needle bearing and
replace as necessary using the appropriate tools
to remove and install (See Figure 127).
Note: If replacement is necessary ensure that
the sealing ring end of the bearing faces rear,
as shown in Figure 127.
3. Install new manual lever seal into case using
the appropriate seal driver (See Figure 128).
4. Install the manual lever, inside detent lever and
park rod assembly, manual lever retaining pin
and torque nut to 48Nm (35 ft.lb.). Refer to
Figure 129.
Note: Do Not allow the wrench to strike the
manual valve inner detent lever pin.
5. Install the number 11 thrust washer into rear
of case, as shown in Figure 130, and retain
with a small amount of Trans-Jel®.
Ford
MANUAL
LINKAGE
SEAL
MANUAL
LINKAGE
MANUAL LINKAGE
RETAINING PIN
Copyright © 2001 ATSG
MANUAL LEVER
RETAINING PIN
INSIDE DETENT
LEVER
PARK ROD

Leave a Reply

Your email address will not be published. Required fields are marked *