Workshop

FORD 5R55N

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
78
Figure 126
Figure 125
Figure 127
Copyright © 2001 ATSG
Copyright © 2001 ATSG
INSTALL BY ALIGNING ARROW ON COVER PLATE
BETWEEN ANY TWO SLOTS ON SERVO HOUSING
INSTALL NEEDLE BEARING ASSEMBLY
WITH SEAL RING FACING REARWARD
REVERSE SERVO
COVER PLATE
REVERSE SERVO PISTON
RETURN SPRING
REVERSE SERVO
HOUSING
CAGED NEEDLE BEARING
SEALING RING
REVERSE SERVO ASSEMBLY (Cont'd)
11. Install the reverse servo cover plate over the
return spring, compress the return spring with
the cover plate and rotate the tabs into position
in the slot, as shown in Figure 125.
12. Caution: The arrow on the cover plate must
be aligned evenly between any two slots on
the reverse servo housing (See Figure 126).
13. Set the completed reverse servo assembly aside
for the final assembly process.
OPENOPEN
Copyright © 2001 ATSG

Leave a Reply

Your email address will not be published. Required fields are marked *