Workshop

FORD 5R55N

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
71
Figure 115 Figure 116
Copyright © 2001 ATSGCopyright © 2001 ATSG
7
N0
6
P-
1
4
-
D
W
A
X
COMPLETED INTERMEDIATE CLUTCH
PISTON AND RETAINER ASSEMBLY
COMPLETED INTERMEDIATE CLUTCH
HOUSING ASSEMBLY
INTERMEDIATE CLUTCH ASSEMBLY (Cont'd)
9. Install the intermediate clutch bellville return
spring into the groove in intermediate clutch
housing, as shown in Figure 114, and ensure
that it is fully seated.
10. Lubricate intermediate clutch molded piston
with a small amount of Trans-Jel®.
11. Lubricate both seal surfaces of the intermediate
clutch piston retainer with a small amount of
Trans-Jel®.
12. Install the intermediate clutch piston into the
intermediate clutch piston retainer, as shown
in Figure 115, with a twisting motion.
13. Set the completed intermediate clutch housing
assembly and completed intermediate clutch
piston retainer assembly aside for the final
assembly process (See Figure 116).
INTERMEDIATE CLUTCH
MOLDED PISTON
INTERMEDIATE CLUTCH
PISTON RETAINER

Leave a Reply

Your email address will not be published. Required fields are marked *