Workshop

FORD 5R55N

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
70
Figure 113 Figure 114
Copyright © 2001 ATSG
"OUTSIDE SPLINE"
INTERMEDIATE CLUTCH
PLATE (4 REQUIRED)
"OUTSIDE SPLINE"
INTERMEDIATE CLUTCH
PLATE (4 REQUIRED)
INTERMEDIATE CLUTCH
HOUSING
INTERMEDIATE CLUTCH
HOUSING
INTERMEDIATE CLUTCH
PISTON BELLVILLE
RETURN SPRING
Copyright © 2001 ATSG
INTERMEDIATE CLUTCH ASSEMBLY (Cont'd)
6. Install the intermediate clutch plates into the
intermediate clutch housing beginning with an
inside spline plate first, with the lining facing
down, as shown in Figure 113.
7. Now alternate with outside spline plates, with
the lining facing down, as shown in Figure 113,
until you have installed four of each plate.
8. The last plate in should be an outside spline
plate, with the lining facing down, as shown
in Figure 113.
Note: These plates have a special off-set
machining on the teeth, so that they will not
assemble in transmission if installed wrong in
the intermediate clutch housing. All friction
plates should be soaked in Mercon V® for
at least 30 minutes before installation.

Leave a Reply

Your email address will not be published. Required fields are marked *