Workshop

FORD 5R55N

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
67
INTERMEDIATE SPRAG ASSEMBLY
4. Place the sprag outer race on a flat work bench
with the lube holes facing up, as illustrated in
Figure 104.
CAUTION: The sprag outer race must be
placed in this position during assembly as
outside splines are cut off-set and will not
assemble into the intermediate clutch plates
even though the outer race freewheels in the
proper direction (See Figure 104).
5. Install one snap ring into the bottom groove in
the sprag outer race, as shown in Figure 104.
6. Install one sprag end bearing on top of the
previously installed snap ring, with grooved
side facing up, as shown in Figure 105.
7. Install the intermediate sprag cage and element
assembly into the outer race, with "Windows"
facing to the left, as shown in Figure 106.
CAUTION: The "Windows" must face in
the direction shown in Figure 106, for sprag
rotation to be correct.
8. Install the second end bearing on top of the
sprag cage with the smooth side facing up, as
shown in Figure 107.
9. Install the second snap ring into the groove in
the outer race, as shown in Figure 108.
10. The completed intermediate sprag assembly
should look like the illustration shown in
Figure 109.
Continued on Page 68
Figure 109
Figure 108
Copyright © 2001 ATSG
Copyright © 2001 ATSG
COMPLETED INTERMEDIATE
SPRAG ASSEMBLY
INTERMEDIATE SPRAG
OUTER RACE
INTERMEDIATE SPRAG
SNAP RING

Leave a Reply

Your email address will not be published. Required fields are marked *