Workshop

FORD 5R55N

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
37
DIRECT CLUTCH
DRUM ASSEMBLY
DIRECT CLUTCH
"SELECTIVE"
THRUST BEARING
(NO. 4)
FORWARD CLUTCH
THRUST BEARING
(NO. 5)
FORWARD CLUTCH
THRUST BEARING
(NO. 6A)
Continued on Page 38
Copyright © 2001 ATSG
INTERNAL COMPONENTS (Cont'd)
45. Remove the center support and set aside for
component rebuild, as shown in Figure 44.
46. Remove the intermediate band assembly and
both band struts, as shown in Figure 45.
Note: Notice the difference in the band struts
and which side they are located, as shown in
Figure 45.
47. Remove and tag for I.D. direct clutch (No. 4)
selective thrust bearing, as shown in Figure 46.
48. Remove the direct clutch housing assembly and
set aside for component rebuild, as shown in
Figure 46.
49. Remove and tag for I.D. forward clutch (No. 5)
thrust bearing, as shown in Figure 46.
50. Remove the forward clutch housing assembly
and set aside for component rebuild, as shown
Figure 46.
51. Remove and tag for I.D. the forward clutch
(No. 6A) thrust bearing (See Figure 46).
Note: This bearing may stick to the forward
clutch housing during removal.
Figure 45 Figure 46
INTERMEDIATE
BAND
BAND STRUT
ADJUST SIDE
BAND STRUT
SERVO SIDE
Copyright © 2001 ATSG
FORWARD CLUTCH
DRUM ASSEMBLY

Leave a Reply

Your email address will not be published. Required fields are marked *