Workshop

FORD 5R55N

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
36
INTERNAL COMPONENTS (Cont'd)
Figure 42
Figure 44
Continued on Page 37
OVERDRIVE CARRIER
AND CENTER SHAFT
ASSEMBLY
CENTER SUPPORT
"TAPERED"
SNAP RING
CENTER SHAFT
THRUST BEARING
(NO. 3)
CENTER SUPPORT
ASSEMBLY
Figure 43
Copyright © 2001 ATSG
Copyright © 2001 ATSG
Copyright © 2001 ATSG
41. Remove the overdrive carrier and center shaft
assembly, as shown in Figure 42.
42. Now, remove the center support retaining bolt
from the case, as shown in Figure 43, and also
remove the locknut, as shown in Figure 44, to
prevent it from falling into the assembly.
43. Remove the center support retaining snap ring
from the case, as shown in Figure 44.
44. Remove center shaft thrust bearing (No. 3)
from the center support, as shown in Figure 44
and tag it for I.D. and location.
Ford
GAS
6540
R3 19 A
6538
R3
T9 A
DA 8
Ford
CENTER SUPPORT
RETAINING BOLT
(20mm LENGTH)
Copyright © 2001 ATSG
96
M 07
1624

Leave a Reply

Your email address will not be published. Required fields are marked *