Workshop

FORD 5R55N

F
ord
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
24
Copyright © 2001 ATSG
Copyright © 2001 ATSG
EXTERNAL COMPONENTS (Cont'd)
5. Remove the two Digital Transmission Range
sensor retaining bolts, as shown in Figure 22,
and remove the sensor.
6. Install a compatible holding fixture onto the
transmission case, as shown in Figure 23, that
will allow you to rotate the transmission when
installed in the bench fixture.
7. Install the transmission into the bench fixture
and rotate, so that extension housing is facing
up, as shown in Figure 24.
8. Remove and discard the output flange retaining
nut, as shown in Figure 24.
9. Using an appropriate puller, remove the output
flange, as shown in Figure 24.
10. Remove the seven extension housing retaining
bolts, using a 10mm socket (See Figure 25).
11. Remove the extension housing and discard the
gasket, as shown in Figure 25.
Caution: The parking pawl, parking pawl
return spring and parking pawl shaft may fall
out of extension housing during removal.
F
ord
F
o
rd
Figure 22
Figure 23
Universal Transmission
Holding Fixture
Digital Transmission
Range Sensor
Retaining Bolts
Continued on Page 26

Leave a Reply

Your email address will not be published. Required fields are marked *