Workshop

FORD 5R55N

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
23
TRANSMISSION DISASSEMBLY
EXTERNAL COMPONENTS
Copyright © 2001 ATSG
Ford
F
o
r
d
1. Remove the turbine shaft from the transmission
as shown in Figure 20. Inspect the spline area
on both ends and set aside for final assembly.
2. Remove the Turbine Shaft Sensor (TSS), the
Intermediate Shaft Sensor (ISS) and the Output
Shaft Sensor (OSS) from the transmission case,
using a 30 Torx bit for the retaining bolts.
(See Figure 20).
3. The Turbine and Output sensors are exactly the
same part number. Refer to Figure 21 for the
differences between them, and the Intermediate
shaft speed sensor.
4. Remove and discard the "O" ring seals from all
three speed sensors, and use the chart found in
Figure 12 to ohms check the sensors for proper
resistance readings.
Turbine Shaft
Speed Sensor
Output Shaft
Speed Sensor
Turbine And Output
Shaft Speed Sensor
Intermediate Shaft
Speed Sensor
Intermediate Shaft
Speed Sensor
Figure 20
Figure 21
Continued on Page 24
Ford
XW4P-7H
103 AA
XW4P-7M
103 AA

Leave a Reply

Your email address will not be published. Required fields are marked *