Workshop

FORD 5R55N

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
102
INTERNAL COMPONENTS (Cont'd)
71. Install the valve body cover plate gasket and
valve body cover plate as shown in Figure 175.
72. Install the ten valve body cover plate bolts in
the exact locations shown in Figure 175, and
finger tighten only.
73. Install the reverse switch onto the cover plate
as shown in Figure 176, finger tighten only and
plug the harness connector into the solenoid
body (See Figure 176).
74. Install pre-assembled reverse servo assembly
onto spacer plate, as shown in Figure 176, and
finger tighten only.
75. Torque the valve body and cover bolts down to
10 Nm (89 in.lb.), beginning in the center and
working outward in a circle.
76. Torque solenoid body bolts to 8 Nm (71 in.lb.).
77. Torque reverse servo bolts to 10 Nm (10 ft.lb.).
Continued on Page 104
Copyright © 2001 ATSG
Figure 175
Ford
GAS
6540
R3 19 A
6538
R3 T9 A
DA 8
Ford
VALVE BODY COVER
PLATE RETAINING BOLTS
(52mm LENGTH)
VALVE BODY
COVER PLATE
VALVE BODY COVER
PLATE GASKET

Leave a Reply

Your email address will not be published. Required fields are marked *