AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
INTERNAL COMPONENTS (Cont'd)
67. Install the pre-assembled valve body assembly
onto the case, as shown in Figure 173.
Caution: Ensure that manual valve is engaged
on inside detent lever properly.
68. Install the valve body retaining bolts into the
exact locations, as shown in Figure 173, finger
tight only, and paying attention to the length of
the bolts to ensure proper location.
69. Install the detent spring and retaining bolt, as
shown in Figure 173, finger tight only.
70. Install the pre-checked solenoid body assembly
onto transmission, as shown in Figure 174, and
finger tighten only.
Note: Refer to Page 5 for solenoid body
specifications as necessary.
Copyright © 2001 ATSG
R3 19 A
R3 T9 A
BOLT (30mm LONG)
Continued on Page 102
INSTALL VALVE BODY ASSEMBLY