Workshop

FORD 5R110W TorqShift

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
99
Copyright © 2004 ATSG Copyright © 2004 ATSG
TRANSMISSION ASSEMBLY
INTERNAL COMPONENTS
Figure 164
84
85
83
82
S
ID
E
S
I
U
H
P
T
1. Rotate the case so that bell housing is facing up
as shown in Figure 164.
2. Install the complete low/reverse clutch pack,
low OWC diode assembly and snap ring, as
shown in Figure 164.
3. Check the low/reverse clutch clearance using a
feeler gauge, as shown in Figure 165.
4. Low/reverse clutch pack clearance should be;
1.81-3.01 mm (.070" - .120").
5. Change the selective snap ring as necessary to
obtain the proper low/reverse clutch clearance.
6. Remove snap ring and complete low/reverse
clutch pack for installation later.
82 LOW OWC DIODE RETAINING SNAP RING
83 LOW OWC DIODE ASSEMBLY
84 LOW/REVERSE CLUTCH FRICTION PLATES (6)
85 LOW/REVERSE CLUTCH STEEL PLATES (6)
Continued on Page 100
Figure 165
Low/Reverse Clutch Clearance Should Be;
1.81 - 3.01 mm (.070" - .120")

Leave a Reply

Your email address will not be published. Required fields are marked *