Workshop

FORD 5R110W TorqShift

2003/2004 MODEL
"1ST DESIGN"
REAR PLANETARY CARRIER
2005/UP MODEL
"2ND DESIGN"
REAR PLANETARY CARRIER
PART NUMBER
5C3Z-7DOO6-AB
"DO NOT USE"
Copyright © 2004 ATSG
Figure 153
Figure 154
1.895"
1.770"
3.110"
2.985"
NOTICE: The rear planetary carrier assembly has
changed for the 2005 production year because of
pinion shafts "walking" in the carrier. The new
design rear planetary carrier has a staking process
change for the pinion pins to prevent them from
"walking" out of the carrier assembly which greatly
improves durability and reliability. There have also
been some dimensional changes which helps us for
identification. The overall height of the carrier has
been reduced by .125" (1/8"), as shown in Figure
153. The splines for the low/reverse frictions have
also been shortened by .125" (1/8"), as shown in
Figure 153.
INTERCHANGEABILITY:
COMPONENT REBUILD
REAR PLANETARY CARRIER DIFFERENCES
The new design planetary carrier "Will" retro-fit
back on all model years, and is required on any
rebuild that has the previous design parts.
Note: "Do Not" reuse "Any" previous design rear
planetary carriers.
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
94
Copyright © 2004 ATSG
REAR PLANETARY CARRIER (CONT'D)
COMPONENT REBUILD
Continued on Page 95
6. Install the number 13 thrust washer on the rear
planetary carrier, as shown in Figure 154, and
retain with Trans-Jel®.
Note: If thrust washers are damaged because
of previous carrier damage, use OEM part
number 3C3Z-7A166-A
Number 13
Thrust Washer
Part Number
3C3Z-7A166-A

Leave a Reply

Your email address will not be published. Required fields are marked *