Workshop

FORD 5R110W TorqShift

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
90
Copyright © 2004 ATSG
COMPLETED FORWARD
CLUTCH HOUSING
COMPLETED FORWARD
INTERNAL RING GEAR
COMPLETED DIRECT
CLUTCH HOUSING
Ensure Number 9
Bearing Is In Place
DRUM AND SUN GEAR SHELL ASSEMBLY
COMPONENT REBUILD
Continued on Page 91
Figure 145 Figure 146
1. Place the completed direct clutch housing on a
flat work surface, as shown in Figure 145.
2. Install the completed forward clutch housing
assembly, as shown in Figure 145, by rotating
back and forth until fully seated and all direct
clutch plates engaged on hub.
Note: Ensure that number 7 thrust washer
and number 8 thrust bearing are still in place
with the Trans-Jel®, before installing.
3. Ensure that the number 9 thrust bearing is still
in place, as shown in Figure 146.
4. Install completed forward ring gear assembly,
as shown in Figure 146, by rotating back and
forth to engage the forward clutch frictions,
until fully seated.
Note: Ensure that number 10 thrust washer is
still in place before installing.

Leave a Reply

Your email address will not be published. Required fields are marked *