Workshop

FORD 5R110W TorqShift

UNIQUE
"LAP" JOINT
UNIQUE
"LAP" JOINT
60 FORWARD CLUTCH SEALING RINGS (2)
61 FORWARD CLUTCH HOUSING ASSEMBLY
61
60
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
80
Copyright © 2004 ATSG
Copyright © 2004 ATSG
Figure 129
Figure 130
FORWARD CLUTCH HOUSING (CONT'D)
DIRECT CLUTCH HOUSING
COMPONENT REBUILD
COMPLETED FORWARD CLUTCH HOUSING
20. Install the two forward clutch sealing rings, as
shown in Figure 129.
Note: Notice the unique "Lap" joint of this
set of seal rings, as shown in Figure 129.
Ensure they are joined properly.
21. Set the completed forward clutch housing aside
for the final drum assembly process, as shown
in Figure 130.
1. Disassemble the direct clutch housing using
Figure 131 as a guide.
2. Inspect all direct clutch parts thoroughly for
any wear and/or damage, replace as necessary.
3. Clean all direct clutch parts thoroughly and
dry with compressed air.
Direct Clutch Housing
Continued on Page 82

Leave a Reply

Your email address will not be published. Required fields are marked *