Workshop

FORD 5R110W TorqShift

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
79
Copyright © 2004 ATSG
FORWARD CLUTCH HOUSING (CONT'D)
13. Tap the clutch pack side of completed forward
clutch housing against the flat work surface to
fully seat the snap ring.
14. Check the forward clutch clearance using feeler
gauge, as shown in Figure 126, between the
backing plate and snap ring.
15. The forward clutch clearance should measure;
1.15 - 1.65 mm (.045" - .065"), as shown in
Figure 126.
16. Change the selective backing plate snap ring
as necessary to obtain the proper clearance.
17. Install the number 9 thrust bearing into the
forward clutch housing, in the direction shown
in Figure 127, and retain with liberal amount
of Trans-Jel®.
18. Install the number 7 thrust washer, as shown
in Figure 128, and retain with Trans-Jel®.
19. Install the number 8 thrust bearing in forward
clutch housing, as shown in Figure 128, and
retain with liberal amount of Trans-Jel®.
Forward Clutch Clearance
Should Be:
1.15-1.65 mm (.045" - .065")
NUMBER 9
THRUST BEARING
58 FORWARD CLUTCH NUMBER 7 THRUST WASHER
59 FORWARD CLUTCH NUMBER 8 THRUST BEARING
60 FORWARD CLUTCH SEALING RINGS (2)
61 FORWARD CLUTCH HOUSING ASSEMBLY
61
60
58
59
Copyright © 2004 ATSG
Figure 126 Figure 128
Figure 127
Continued on Page 80

Leave a Reply

Your email address will not be published. Required fields are marked *