Workshop

FORD 5R110W TorqShift

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
72
Copyright © 2004 ATSG Copyright © 2004 ATSG
Copyright © 2004 ATSG
38
38
42
41
UNIQUE
"LAP" JOINT
UNIQUE
"LAP" JOINT
38 CENTER SUPPORT ASSEMBLY
42 NUMBER 6 THRUST WASHER
38 CENTER SUPPORT ASSEMBLY
41 DIRECT CLUTCH TEFLON® SEALING RINGS (2 REQUIRED)
COMPLETED CENTER SUPPORT ASSEMBLY
Figure 113 Figure 115
Figure 114
COMPONENT REBUILD
CENTER SUPPORT ASSEMBLY
10. Install the number 6 thrust washer onto the
center support, as shown in Figure 113, and
retain with a small amount of Trans-Jel®.
11. Install new direct clutch sealing rings into the
grooves in the center support (See Figure 114).
12. Notice that the rings have a "unique" lap joint,
as shown in Figure 114, and will require some
special attention, to ensure that they engage
properly.
13. Set the completed center support assembly, as
shown in Figure 115, aside for final assemby.
Component Rebuild
Continued on Page 75

Leave a Reply

Your email address will not be published. Required fields are marked *