Workshop

FORD 5R110W TorqShift

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
71
Copyright © 2004 ATSG Copyright © 2004 ATSG
38 CENTER SUPPORT ASSEMBLY
44 INTERMEDIATE CLUTCH PISTON RETURN SPRNG ASSEMBLY
38 CENTER SUPPORT ASSEMBLY
43 INTERMEDIATE CLUTCH MOLDED PISTON
38 38
44
45
43
COMPONENT REBUILD
CENTER SUPPORT ASSEMBLY
Figure 111 Figure 112
1. Disassemble the center support assembly using
Figure 110 as a guide.
2. Inspect all center support parts thoroughly for
any wear and/or damage.
3. Clean all center support parts thoroughly and
dry with compressed air.
4. Set center support on a flat work surface, as
shown in Figure 111.
5. Lubricate new intermediate clutch piston seals
with a small amount of Trans-Jel®.
6. Install the intermediate clutch piston into the
center support, as shown in Figure 111.
7. Install the intermediate clutch piston return
spring in direction shown in Figure 112.
8. Compress the return spring using appropriate
spring compressor and install snap ring.
9. Ensure that snap ring is fully seated in groove.
Continued on Page 72

Leave a Reply

Your email address will not be published. Required fields are marked *