Workshop

FORD 5R110W TorqShift

ASSEMBLY TOOL
307 S383
SUPPORT
BLOCKS
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
69
Copyright © 2004 ATSG
Figure 108 Figure 109
Copyright © 2004 ATSG
36
35
34
33
NUMBER 5
THRUST BEARING
COMPLETED OVERDRIVE RING GEAR
AND CENTER SHAFT ASSEMBLY
33 OVERDRIVE INTERNAL RING GEAR
34 CENTER SHAFT ASSEMBLY
35 CENTER SHAFT TO RING GEAR SNAP RING
COMPONENT REBUILD
OVERDRIVE SECTION (CONT'D)
9. Turn the assembly over once again onto the set
of blocks, as shown in Figure 108, and install
the special installation tool 307-S383.
10. Tighten the special tool securely and set the
assembly aside for the final assembly process.
11. It is not necessary to disassemble the internal
ring gear and hub assembly, unless damage is
apparent.
12. If replacement parts were needed at this time,
use Figure 109 for assembly and disassembly
of the ring gear and hub.
13. Set the overdrive ring gear and hub assembly
aside for the final assembly process.

Leave a Reply

Your email address will not be published. Required fields are marked *