Workshop

FORD 5R110W TorqShift

9.89.8
KXVKXV
9.8
KXV
9.8
KXV
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
68
Copyright © 2004 ATSG
Copyright © 2004 ATSG
NUMBER 4
THRUST BEARING
TORQUE SPECIFICATIONS
1. TORQUE EVENLY TO 30 N°M (22 FT.LB.)
2. TIGHTEN AN ADDITIONAL 90 DEGREES
Figure 105
Figure 107Figure 106
COMPONENT REBUILD
OVERDRIVE SECTION (CONT'D)
5. If it was necessary to replace the overdrive
planetary carrier or the coast clutch hub, torque
the new bolts as shown in Figure 105.
Note: Do not over-torque or you will have to
start again with more new bolts.
6. Set the coast clutch hub and overdrive carrier
assembly onto a set of blocks, as shown in
Figure 106.
7. Install the previously completed coast clutch
housing onto the coast clutch hub, by rotating
back and forth, to engage all friction plates on
the hub and ensure it is fully seated. Refer to
Figure 106.
8. Turn the entire assembly over and install the
number 4 thrust bearing, in the direction shown
in Figure 107, and retain with a small amount
of Trans-Jel®.
9.89.8
KXVKXV
9.8
KXV
9.8
KXV
COMPLETED COAST
CLUTCH HOUSING
ASSEMBLY
COAST CLUTCH HUB
OVERDRIVE CARRIER
ASSEMBLY
SUPPORT
BLOCKS
Copyright © 2004 ATSG
Continued on Page 69

Leave a Reply

Your email address will not be published. Required fields are marked *