Workshop

FORD 5R110W TorqShift

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
67
9.8
KXV
9.8
KXV
9.8
KXV
9.8
KXV
Copyright © 2004 ATSG
"PTO" APPLICATIONS
COAST CLUTCH
HUB ASSEMBLY
OVERDRIVE
PLANETARY
CARRIER
RETAINING
BOLTS (4 REQ)
9.8
KXV
9.8
KXV
9.8
KXV
9.8
KXV
Copyright © 2004 ATSG
"NON-PTO" APPLICATIONS
COAST CLUTCH
HUB ASSEMBLY
OVERDRIVE
PLANETARY
CARRIER
RETAINING
BOLTS (4 REQ)
COMPONENT REBUILD
OVERDRIVE SECTION
Figure 103 Figure 104
1. Disassemble the overdrive section parts using
Figure 102 as a guide.
Note: It is not necessary to remove the coast
clutch hub assembly from the overdrive
planetary carrier, unless damage is apparent.
2. Inspect all overdrive section parts thoroughly
for any wear and/or damage.
3. Clean all overdrive parts thoroughly and dry
with compressed air.
Note: Do not spin the planetary pinions with
air as damage may occur.
4. If it does become necessary to replace either
overdrive planetary carrier or the coast clutch
hub, remove the bolts as shown in Figure 103
and Figure 104.
Note: These bolts "CANNOT" be reused
because of the torquing procedure. They
"MUST" be replaced with new bolts.
Continued on Page 68

Leave a Reply

Your email address will not be published. Required fields are marked *