Workshop

FORD 5R110W TorqShift

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
65
SI
D
E
U
IS
P
TH
25
26
28
20
24
20 COAST CLUTCH HOUSING ASSEMBLY.
24 COAST CLUTCH FRICTION PLATES (3 REQUIRED).
25 COAST CLUTCH STEEL PLATES (3 REQUIRED).
26 COAST CLUTCH BACKING PLATE/ONE-WAY CLUTCH ASSEMBLY.
28 COAST CLUTCH BACKING PLATE SNAP RING.
Copyright © 2004 ATSG
SI
D
E
U
IS
P
TH
Coast Clutch Clearance Should Be
0.76 - 1.27mm (.030" - .050")
Copyright © 2004 ATSG
COMPONENT REBUILD
COAST CLUTCH HOUSING (CONT'D)
10. Install the coast clutches beginning with a steel
plate and alternating with friction plates until
you have installed three of each, as shown in
Figure 100.
11. Install the coast clutch backing plate and O.D.
one-way clutch assembly, into the coast clutch
housing in the direction shown in Figure 100.
Note: The words "This Side Up" must be
visible after installation (See Figure 97).
12. Install the coast clutch backing plate snap ring
into the housing, as shown in Figure 100, and
ensure that it is fully seated.
13. Turn the coast clutch drum over and tap against
the work bench to seat the snap ring to the top
of the groove.
14. Measure between the snap ring and the backing
plate, as shown in Figure 101, with a feeler
gauge to determine clutch clearance.
15. Proper coast clutch clearance should be:
.76-1.27 mm (.030"-.050").
16. Change the selective snap ring as necessary to
obtain the proper coast clutch clearance.
17. Set the completed coast clutch housing aside
for the final assembly process.
Figure 100 Figure 101

Leave a Reply

Your email address will not be published. Required fields are marked *