Workshop

FORD 5R110W TorqShift

10 PUMP TO COAST CLUTCH DRUM (NO 1) THRUST WASHER.
13 PUMP SUPPORT TO COAST CLUTCH (NO 2) THRUST BEARING.
Copyright © 2004 ATSG
9.8
KXV
9.8
KXV
9.8
KXV
9.8
KXV
9.8
KXV
9.8
KXV
9.8
KXV
Copyright © 2004 ATSG
Copyright © 2004 ATSG
9.8
KXV
9.8
KXV
9.8
KXV
9.8
KXV
9.8
KXV
9.8
KXV
TORQUE TO 31 N·M (23 FT.LB.)
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
61
Continued on Page 62
21. Install the 5 remaining pump cover to pump
body bolts in the locations shown in Figure 91
and hand tighten only.
22. Install and tighten the alignment strap around
the pump body and cover (See Figure 92).
23. Torque all pump cover to pump body bolts to
31 N•m (23 ft.lb.) as shown in Figure 92.
24. Install the number 1 thrust washer, as shown
in Figure 93, and retain with a small amount
of Trans-Jel®.
25. Install the number 2 thrust bearing onto stator
shaft, in the direction shown in Figure 93, and
retain with a small amount of Trans-Jel®.
COMPONENT REBUILD
OIL PUMP ASSEMBLY (CONT'D)
Figure 91 Figure 93
Figure 92
ALIGNMENT
STRAP
13
10

Leave a Reply

Your email address will not be published. Required fields are marked *