Workshop

FORD 5R110W TorqShift

Sna
p-On
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
58
Copyright © 2004 ATSG
Copyright © 2004 ATSG
COAST CLUTCH
SEAL RINGS
STATOR SHAFT
ASSEMBLY
RETAINING
BOLTS (3 REQ)
OIL PUMP
COVER
TORQUE TO 9-11 N·M (80-100 IN.LB.)
Copyright © 2004 ATSG
OIL PUMP
WEAR PLATE
ALIGNMENT
DOWELS
10. Install 2 alignment dowels made from spare
bolts in pump body, as shown in Figure 85.
11. Install the oil pump wear plate over the dowels,
as shown in Figure 85.
12. It is not necessary to remove the stator shaft
from pump cover unless damage is apparent.
13. If it was removed, install the stator shaft and
torque the bolts to 9-11 N•m (80-100 in.lb.) as
shown in Figure 86 and 87.
14. Install 2 new coast clutch scarf-cut seal rings
onto the stator shaft, as shown in Figure 87.
15. Install the valves, springs, bore plugs and the
retainers, exactly as shown in Figure 88.
Note: Retainer locations are also shown
in Figure 88.
16. Prior to installation, lubricate valves and bore
plugs with transmission fluid.
COMPONENT REBUILD
OIL PUMP ASSEMBLY (CONT'D)
Figure 85 Figure 87
Figure 86
Continued on Page 60

Leave a Reply

Your email address will not be published. Required fields are marked *