Workshop

FORD 5R110W TorqShift

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
54
Copyright © 2004 ATSG
COMPONENT REBUILD
SOLENOID BODY ASSEMBLY
14. Install new reinforcing plate gasket on channel
plate, as shown in Figure 79.
15. Install reinforcing plate and 5 bolts, as shown
in Figure 79, and hand tighten only.
16. Install new solenoid body to channel plate
screen/gasket, as shown in Figure 79.
17. Install the previously completed solenoid body
assembly, as shown in Figure 79.
18. Install the 4 solenoid body to channel plate
bolts in the locations shown in Figure 79, and
hand tighten only at this time.
19. Install the wire harness to channel plate bolts
as shown in Figure 79.
20. Set the completed solenoid body aside for the
final assembly process (See Figure 80).
REINFORCING PLATE
TO CHANNEL PLATE
(16 MM) (5 REQUIRED)
REINFORCING
PLATE
REINFORCING
PLATE GASKET
CHANNEL PLATE
SOLENOID BODY
SCREEN/GASKET
SOLENOID BODY
TO CHANNEL PLATE
(27 MM) (3 REQUIRED)
SOLENOID BODY
TO CHANNEL PLATE
(55 MM) (1 REQUIRED)
WIRE HARNESS
15.5 MM
(2 REQUIRED)
SOLENOID BODY
ASSEMBLY
SOLENOID BODY
TO CHANNEL PLATE
(27 MM) (3 REQUIRED)
Figure 79
Continued on Page 55

Leave a Reply

Your email address will not be published. Required fields are marked *