Workshop

FORD 5R110W TorqShift

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
50
Copyright © 2004 ATSG
REINFORCING PLATE
TO CHANNEL PLATE
(16 MM) (5 REQUIRED)
SOLENOID BODY
TO CHANNEL PLATE
(27 MM) (3 REQUIRED)
SOLENOID BODY
TO CHANNEL PLATE
(55 MM) (1 REQUIRED)
WIRE HARNESS
15.5 MM
(2 REQUIRED)
REINFORCING
PLATE
REINFORCING
PLATE GASKET
CHANNEL PLATE
SOLENOID
BODY GASKET
SOLENOID BODY
ASSEMBLY
SOLENOID BODY
TO CHANNEL PLATE
(27 MM) (3 REQUIRED)
Figure 73
1. Remove the 4 bolts that retain the solenoid
body to the channel plate and one bolt into the
channel plate for internal wiring harness, as
shown in Figure 73.
2. Remove the 5 bolts holding the reinforcing
plate to the channel plate and discard gasket, as
shown in Figure 73.
COMPONENT REBUILD
SOLENOID BODY ASSEMBLY
Continued on Page 52

Leave a Reply

Your email address will not be published. Required fields are marked *