Workshop

FORD 5R110W TorqShift

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
49
Copyright © 2004 ATSG
F5
004361004361
PDT-25PDT-25
180302180302
A4522A4522
303P-7000-KB303P-7000-KB
9.89.8
9.89.8
9.89.8
9.89.8
9.89.8
Figure 71
Figure 70
Figure 72
OUTPUT SHAFT
NUT DRIVER
(307-458)
"O" RING
OUTPUT SHAFT
NUT
OUTPUT SHAFT
NUT GROOVE
"4WD VERSION"
Copyright © 2004 ATSG
F5
004361004361
P
DT-25P
DT-25
1
803021
80302
A4522A4522
303P-7000-KB303P-7000-KB
9.89.8
9.89.8
9.89.8
9.89.8
9.89.8
TRANSMISSION CASE (Cont'd)
COMPONENT REBUILD
Continued on Page 50
32. Install new "O" ring into the groove in output
shaft nut, as shown in Figure 70, and lube with
a small amount of Trans-Jel®.
33. Install the output shaft nut onto output shaft,
using the special nut driver 307-458, as shown
in Figure 71, and hand tighten.
34. Torque the output shaft nut, using 1/2" drive
torque wrench, to 200 N•m (148 ft.lb.), as
shown in Figure 72.
35. Transmission case is now ready for the final
assembly process. Rotate the transmission so
that bell housing is facing up.
TORQUE OUTPUT SHAFT NUT
TO 200 N•m (148 ft.lb.)

Leave a Reply

Your email address will not be published. Required fields are marked *