Workshop

FORD 5R110W TorqShift

F
5
004361004361
P
DT-25P
DT-25
18030
218030
2
A4522
A4522
303P-7000
-K
B303P-7000
-K
B
9.
8
9.
8
9.8
9.8
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
47
Figure 67Figure 66
Copyright © 2004 ATSG Copyright © 2004 ATSG
RETURN SPRING
IS HOOKED ON
CASE
RETURN SPRING
IS HOOKED ON
CASE
ENSURE THAT
PARK ROD
TRAVELS FREELY
ENSURE THAT
PARK ROD
TRAVELS FREELY
THIS TORX HEAD BOLT
MUST BE DISCARDED AND
REPLACED, IF REMOVED
THIS TORX HEAD BOLT
MUST BE DISCARDED AND
REPLACED, IF REMOVED
TRANSMISSION CASE (Cont'd)
Continued on Page 48
23. Install a new lube orifice plug in the case, as
shown in Figure 65.
24. Before installing extension housing, ensure that
park pawl return spring is hooked behind the
case, and park rod operates freely through the
guide plate (See Figure 66).
25. The Torx head bolt retaining the parking pawl
abutment plate, shown in Figure 66, has thread
locking compound and should not be removed
unless damage is apparent.
Note: If it was removed, Ford recommends
that it be discarded and a new bolt installed
and torqued to 16-27 N•m (12-20 ft.lb.).
26. Install new extension housing seal using the
proper seal driver (See Figure 67).
Note: 4WD version is shown, 2WD similiar.
27. Replace the ball bearing in the 4WD version
as necessary using the proper drivers. Refer to
Figure 67.
"4WD VERSION"
9.
8
9.
8
9.
8
9.
8
LUBE ORIFICE
PLUG
Copyright © 2004 ATSG
Figure 65

Leave a Reply

Your email address will not be published. Required fields are marked *