Workshop

FORD 5R110W TorqShift

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
45
COMPONENT REBUILD
TRANSMISSION CASE (Cont'd)
Continued on Page 46
15. Torque the transmission range sensor retaining
bolts to 10 N•m (89 in.lb.) (See Figure 60).
16. Rotate transmission in fixture so that the rear
surface is facing up, as shown in Figure 61.
17. Install the parking pawl, pivot pin and return
spring, as shown in Figure 61, and ensure that
return spring is hooked properly behind case.
18. Install the parking rod guide plate, as shown in
Figure 61.
19. Install the two park rod guide plate retaining
bolts and torque to 24 N•m (18 ft.lb.).
Note: Ensure that park rod operates freely
through the guide plate.
20. Install the number 17 thrust bearing onto the
case, in the direction shown in Figure 62, and
retain with a small amount of Trans-Jel®.
Note: Some models use a Number 17 thrust
"washer" between case and park gear instead
of a thrust bearing.
Copyright © 2004 ATSG
Copyright © 2004 ATSG
F5
004361004361
PDT-25PDT-25
180302180302
A4522A4522
303P-
7000-KB303P-
7000-KB
RETAINING
BOLTS
PARK PAWL,
PIVOT PIN,
AND RETURN
SPRING
PARK ROD
GUIDE PLATE
9.8
9.8
Figure 61
Figure 62Figure 60
Copyright © 2004 ATSG
F5
004361004361
PDT-25PDT-25
18
030218
0302
A4522A4522
303P-7
0
00-KB303P-7
0
00-KB
9.
8
9.
8
9.
8
9.
8
NUMBER 17
THRUST BEARING

Leave a Reply

Your email address will not be published. Required fields are marked *