Workshop

FORD 5R110W TorqShift

TRANSMISSION DISASSEMBLY
INTERNAL COMPONENTS (CONT'D)
60. The 2WD version is shown in Figure 52, which
is basically the same as the 4WD version.
Note: Some models use a Number 17 thrust
washer between park gear and case instead
of a thrust bearing.
61. Remove the park rod guide plate, parking pawl,
park pawl pivot pin and return spring, as shown
in Figure 53.
62. Rotate the transmission in fixture so that bell
housing is facing up, as shown in Figure 54.
63. Using a suitable spring compressor, compress
the low/reverse clutch piston return spring and
remove the snap ring (See Figure 54).
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
42
Copyright © 2004 ATSG
Figure 53
F5
004361004361
PDT-25PDT-25
180302180302
A4522A4522
303P-7000-KB303P-7000-KB
Figure 54
RETAINING
BOLTS
PARK PAWL,
PIVOT PIN,
AND RETURN
SPRING
PARK ROD
GUIDE PLATE
9.8
9.8
Continued on Page 43
64. Remove the low/reverse clutch piston return
spring assembly, as shown in Figure 54.
65. Remove the low/reverse clutch apply piston,
as shown in Figure 54.
Copyright © 2004 ATSG
94
93
92
92 LOW/REVERSE CLUTCH RETURN SPRING SNAP RING
93 LOW/REVERSE CLUTCH RETURN SPRING ASSEMBLY
94 LOW/REVERSE CLUTCH PISTON

Leave a Reply

Your email address will not be published. Required fields are marked *