Workshop

FORD 5R110W TorqShift

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
39
Copyright © 2004 ATSG
TRANSMISSION DISASSEMBLY
INTERNAL COMPONENTS (CONT'D)
48. Remove the low diode retaining snap ring from
the case groove (See Figure 47).
49. Remove the low diode, low/reverse clutch pack
and rear planetary carrier as an assembly, as
shown in Figure 47.
50. Remove the rear carrier to rear ring gear thrust
bearing (Number 15), as shown in Figure 47.
51. Remove the rear planetary ring gear assembly
and the number 16 thrust bearing, as shown in
Figure 47.
52. Rotate the transmission in holding fixture so
extension housing is facing up, as shown in
Figure 48.
Note: 4WD version is shown.
53. Using the special socket 307-458, as shown in
Figure 48, loosen the output shaft nut on the
4WD version.
Continued on Page 40
S
ID
E
S
I
U
H
P
T
S
ID
E
S
I
U
H
P
T
82
71 NUMBER 15 THRUST BEARING ASSEMBLY
82 LOW DIODE RETAINING SNAP RING
86 LOW DIODE, L/R CLUTCHES, REAR PLANETARY CARRIER
88 REAR PLANETARY CARRIER INTERNAL RING GEAR
91 NUMBER 16 THRUST BEARING ASSEMBLY
88
91
71
86
Figure 47 Figure 48
OUTPUT SHAFT
NUT DRIVER
(307-458)
Copyright © 2004 ATSG
F5
004361004361
P
DT-25P
DT-25
1
803021
80302
A4522A4522
303P-7000-KB303P-7000-KB
9.89.8
9.89.8
9.89.8
9.89.8
9.89.8

Leave a Reply

Your email address will not be published. Required fields are marked *