Workshop

FORD 5R110W TorqShift

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
35
Copyright © 2004 ATSG
HH
HH
HH
16
17
20
18
19
16 OVERDRIVE CLUTCH FRICTION PLATES (3 REQUIRED).
17 OVERDRIVE CLUTCH STEEL PLATES (3 REQUIRED).
18 OVERDRIVE CLUTCH BACKING PLATE.
19 OVERDRIVE CLUTCH BACKING PLATE SNAP RING.
20 COAST CLUTCH HOUSING ASSEMBLY.
TRANSMISSION DISASSEMBLY
INTERNAL COMPONENTS (CONT'D)
27. Remove the pump support to coast clutch drum
(No. 1) thrust washer (See Figure 39).
28. Remove the pump support to coast clutch drum
(No. 2) thrust bearing (See Figure 39).
Note: Both thrust washer and bearing may
be stuck to back of pump support.
29. Remove the overdrive steel and lined plates, as
shown in Figure 40.
30. Remove the coast clutch housing assembly, by
lifting straight up, as shown in Figure 40.
31. Set the coast clutch housing assembly aside for
the component rebuild section.
32. Remove the overdrive clutch backing plate, as
shown in Figure 40.
33. Remove the overdrive clutch backing plate
snap ring from case groove and remove from
transmission, as shown in Figure 40.
Continued on Page 36
Figure 40

Leave a Reply

Your email address will not be published. Required fields are marked *