AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
INTERNAL COMPONENTS (CONT'D)
Continued on Page 107
29. Rotate the transmission so that the pan surface
is facing up, as shown in Figure 178.
30. Now, torque the new center support bolts to,
32 N•m (24 ft.lb.), as shown in Figure 178.
31. Install the forward clutch orifice on top of the
center support bolt, as shown in Figure 179.
Note: Retain forward clutch orifice with a
small amount of Trans-Jel®.
32. Install a new channel plate to case gasket, as
shown in Figure 179, over the locating dowels.
TORQUE NEW FEED BOLTS TO
32 N•M (24 FT.LB.)
Copyright © 2004 ATSG
TO CASE GASKET