Workshop

FORD 5R110W TorqShift

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
104
Figure 174 Figure 175
TRANSMISSION ASSEMBLY
INTERNAL COMPONENTS (CONT'D)
HH
HH
HH
16
17
18
19
Copyright © 2004 ATSG
Continued on Page 105
21. Install the overdrive backing plate snap ring, as
shown in Figure 174, with the opening in the
six o' clock position in the case.
Note: This is a flat snap ring.
22. Install the overdrive clutch backing plate into
the case, as shown in Figure 174.
23. Install the overdrive clutch plates, as shown in
Figure 174, beginning with a friction plate and
alternating with steel plates.
Note: Friction plates should be soaked with
Mercon SP® before installation.
24. Install alignment dowels 307-456, as shown in
Figure 175.
25. Install new pump to case gasket over alignment
dowels, as shown in Figure 175.
Copyright © 2004 ATSG
16 OVERDRIVE CLUTCH FRICTION PLATES (3 REQUIRED).
17 OVERDRIVE CLUTCH STEEL PLATES (3 REQUIRED).
18 OVERDRIVE CLUTCH BACKING PLATE.
11 OIL PUMP ASSEMBLY TO CASE GASKET
11
ALIGNMENT
DOWELS
307-456

Leave a Reply

Your email address will not be published. Required fields are marked *