Workshop

FORD 5R110W TorqShift

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
103
TRANSMISSION ASSEMBLY
INTERNAL COMPONENTS (CONT'D)
Figure 172 Figure 173
32
30
33
36
TRANSMISSION ASSEMBLY
INTERNAL COMPONENTS (CONT'D)
Continued on Page 104
19. Install the pre-assembled overdrive ring gear
and center shaft, as shown in Figure 172.
Note: Ensure the number 5 thrust bearing is
still in place on center shaft.
20. Install the pre-assembled coast clutch housing
and overdrive carrier assembly, as shown in
Figure 173, by rotating into position using the
special assembly tool 307 S383.
Note: Ensure that number 4 thrust bearing is
still in place on overdrive carrier.
Copyright © 2004 ATSGCopyright © 2004 ATSG
33 OVERDRIVE RING GEAR AND CENTER SHAFT ASSEMBLY
36 NUMBER 5 THRUST BEARING ASSEMBLY
30 COAST CLUTCH DRUM AND OVERDRIVE CARRIER ASSEMBLY
32 NUMBER 4 THRUST BEARING ASSEMBLY
ASSEMBLY TOOL
307 S383

Leave a Reply

Your email address will not be published. Required fields are marked *