Workshop

FORD 5R110W TorqShift

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
100
Figure 167
TRANSMISSION ASSEMBLY
INTERNAL COMPONENTS (CONT'D)
7. Check the bottom of the case one more time to
ensure snap ring for low/reverse clutch piston
return spring is seated properly.
8. Install the pre-assembled rear ring gear and
thrust bearings, as shown in Figure 166.
Note: Ensure number 16 bearing is still in
place on back side.
9. Install the 2005 style rear planetary carrier, as
shown in Figure 166, by rotating into position.
Note: Ensure that number 13 and 14 thrust
washers are still in place.
Copyright © 2004 ATSG
91
88
71
87
71 NUMBER 15 THRUST BEARING ASSEMBLY
87 REAR PLANETARY CARRIER ASSEMBLY
88 REAR PLANETARY CARRIER INTERNAL RING GEAR
Figure 166
10. Re-install low/reverse clutch plates, as shown
in Figure 167, beginning with a steel plate and
alternating with friction plates, until you have
installed six of each.
Note: Low/reverse friction plates should be
soaked in Mercon SP® before installing.
Copyright © 2004 ATSG
84
85
84 LOW/REVERSE CLUTCH FRICTION PLATES (6)
85 LOW/REVERSE CLUTCH STEEL PLATES (6)
Continued on Page 101

Leave a Reply

Your email address will not be published. Required fields are marked *